What is Building Wire?
Jul 18, 2023
H07RN-F Rubber Cable
H07RN-F is a heavy-duty rubber flexible power supply trailing cable designed to give high flexibility and endure chemical, mechanical, and thermal loads.
Solar Cable
Solar cable (PV Cable/Wire ) is used in the low-voltage DC transmission part of the solar photovoltaic power generation system.
Aluminum Clad Steel Wire (ACS)
The conductor weight is 5% lighter and the current-carrying capacity is 2-3% higher when compared to ordinary aluminum cable steel reinforced.
600V Duplex Conductor URD Cable
Duplex Aluminum 600V URD cable is intended for use in secondary distribution circuits in duct or direct burial installations. In both wet and dry locations, the maximum operating temperature should not exceed 90°C. Voltage rating is 600 volts. As an option, this cable can be provided pre-pulled into duct. It is made up of a 1350-H19 aluminum conductor that has been stranded or compressed, as well as crosslinked polyethylene insulation. Surface printed insulated conductors with neutral triple yellow stripes. If desired, black neutrals can be specified.
XLPE Insulated Control Cable
Control cable is a multistrand cable used to transmit information on the state, location, or operating conditions of items being controlled; it is employed when direct access to such objects is difficult or impossible. Control cables exist between power cables and communications lines.
It is suited for wiring electric controlling equipment and instruments, monitoring and regulating return circuits, electrical protection and measurement in power distribution units with rated voltages of up to 450/750 AC.
Rubber Cable
Rubber cable is formed by fine copper wire as conductor, rubber insulation and rubber sheathed. Including general rubber cable welding cable, submersible pump cable etc….
Bare Copper Conductor (HDBC)
Bare Conductor can be used in electrical grounding systems.
600V Triplex URD Cable
The 600V Triplex Conductor URD cable is intended for use in secondary distribution circuits in duct or direct burial installations. In both wet and dry locations, the maximum operating temperature should not exceed 90°C. Voltage rating is 600 volts. This cable can be supplied with a pre-pulled intoduct as an option. It is made up of crosslinked polyethylene insulation and concentrated stranded or compressed 1350-H19 aluminum conductors. Surface printed insulated conductors with neutral triple yellow stripes. Two phase and one neutral conductor twisted together (LH lay) or parallel if so specified. If desired, black neutrals can be specified.
TC Control Cable
TC Control cable (Type TC-ER) is utilized in industrial power or control circuits when small diameter, flame retardant cables are necessary. Primary installations include cable trays, raceways, and outdoor sites where a messenger wire is supported. It is also for direct burial and used in Class 1, Division 2 hazardous areas and Class 1 control circuits. Conductors must be used at temperatures no higher than 75°C in damp areas and 90°C in dry areas.
Concentric Cable
Concentric cable is a kind of cable to prevent energy loss. It is divided into copper core cable and aluminum core cable. The voltage is 0.6/1KV.
Covered Line Wire (ASTM Standard)
Covered Line Wire is designed for use on overhead secondary distribution lines.